The Fullbore Metal Distortion provides high-gain distortion a 3-band EQ, a midrange sweep control, a Scoop switch, and a switchable Noise Gate with internal sensitivity control. This pedal can be powered by a 9-volt battery, a Dunlop ECB003 9-volt adapter, or the DC Brick™, Iso-Brick™, and Mini Iso-Brick™ power supplies (not included).

* Super high-gain distortion
* 3-band EQ with midrange sweep
* SCOOP switch boosts highs and lows
* Switchable Noise Gate with sensitivity control

DIRECTIONS

* Run a cable from your guitar to the Fullbore Metal’s INPUT jack and run another cable from the Fullbore Metal’s OUTPUT jack to your amplifier.
* NOTE: Start with Volume, Gain, and Bass at their lowest setting (fully counterclockwise). This pedal is very dynamic and adds tons of gain—be warned!
* Turn the effect on by depressing the footswitch.
* Adjust the Gain, Volume, Low, Mid, Freq and High controls until the desired output and tone is acquired.
* Depress the SCOOP button (red LED lit) for a scooped nu-metal sound that accentuates the low and high frequencies.
* To sharpen the attack of syncopated rhythms or to cut down on excess noise, depress the GATE button (green LED lit). To adjust the GATE control’s sensitivity, please refer to diagram A